Hydroponic – 4 Months Later
It has been 4 of months since the Arduino-based hydroponic control system has been in operation and I’ve since harvested arugula and lettuce. I’ve added a couple of columns to to grow cherry tomatoes. For the most part it has been a good experience.
I’ve finally added EC and pH measurement from Atlas Scientific and programmed it using I2C rather than serial. I also added voltage isolation between the probe and the rest of circuitry to reduce changes of noise interference. Data collected is via modbus over xbee to my SCADA host as before. The updated wiring includes the two extra sensors as shown below.
The spike in measurement resulted from adding more nutrient and pH down to the nutrient tank. More about that later.
New Development Environment
- Inconsistent distribution of flow. The drip lines where sitting at the top and some plants would not get enough water. Fix: added 2″ caps (orange in pic) ensuring proper alignment of drip line.
- Water leaking to the floor. I could have done a better job in making the holes to host the net pots. When harvested, I would have to keep an empty net pot to avoid dripping of water. Fix: Replaced with 2″ Wye. It holds a 2″ net pot nicely. I could not find white wyes that did not cost and arm and a leg. I opted for the black drainage type. The photo shows a trial test.
- 3″ net pots to hold cherry tomatoes is throwaway. The holes where made into 4″ pipe and it caused all kinds of issues. Fix: Replace with TODO wyes.
- Drain pump. The one I bought is too slow and noisy. Fix: I use a wet vac to drain the water. It is a lot faster and helps with cleaning the tank.
- Level Sensor: The sensor got destroyed with the splashing of the nutrient mixture over time. Also, the readings on average were correct but I did not like the range in level during operation. Fix: Removed and looking for different sensor.
- Topping off nutrients is ok a the start but after a while, I just want to system to take care of it all. One has to add it over a period of time rather than in one shot. Otherwise, spikes in pH/EC occur. Fix: purchased nutrient containers and some peristaltic pumps. With some TODO driver circuitry and code, managing nutrients should be mostly automated.
The following plot represents nutrient temperature and growing chamber temperature. The nutrient temperature is on the low end of the range and I’m going to test to see if keeping the temperature around 21C (70F) impacts the growing cycle.
The fun stuff begins and it is machine vision. One to assess how well photosynthesis is occurring and the other is to measure growth.